Home > Western Digital > Western Digital Harddrive Error

Western Digital Harddrive Error

Does it have a correct file format and a drive letter? A clicking noise can indicate that this error has occurred. Error logging capability: (0x01)Error logging supported. Did WD raise any flags on it?4. check over here

I tried reconnecting it using a data cable from my Nokia, works fine. When it does identify it, follow the next steps that I mention before. Thanks, Roger -------------------------------------------- === START OF INFORMATION SECTION === Model Family: Western Digital Caviar Black Device Model: WDC WD5001AALS-00E3A0 Serial Number: WD-WCATR2850613 LU WWN Device Id: 5 0014ee 2afa8f8cb Replace the drive if the error repeats. Visit Website

Privacy Policy Terms of Use Trademarks Select your Language Language 中文(繁體) 中文(简体) Čeština Deutsch English Español Francais ελληνικά Italiano 日本語 한국어 Polski Português РУССКИЙ Türk Return to WDC.com WD Community Contact Drive should be replaced. She's so worried right now. Test the drive on another system.

http://products.wdc.com/support/kb.ashx?id=DHvrVDThey might be able to estimate how lucky you will be. Replace the drive if the error repeats. But you get the slower transfer rate of USB 2.0. Please re-test the drive with Data Lifeguard.

The printer may not be attached or turned on. If the error repeats, replace the drive. All files recovered. Retest after checking the connections.

The hard drive still lights up, weird noises then after a while the noises stop but HD still lighted up. Will they give approval for Data Recovery from third party? The failure to complete the test indicates a failed drive. Replace the drive.

Re-test Drive 220 Drive is Locked Security feature of the drive reports locked status. This error may also appear if the floppy has been infected by a hidden virus. This may be due to a defect with the drive or the drive may not have responded properly due to a bad connection. Drive should be replaced.

It worked. check my blog Replace the drive if the error repeats. I would recommend you to test the drive on another PC and with another USB cable. This may be an anomaly or a defect with the drive.

Replace the drive if the error repeats. I've read a number of forum posts regarding the issue and checked that:a) the HD does not show up in that BIOS.b) when I open disk management, the HD does show It also may be due to a defective connection. this content YOU DON'T NEED TO LOSE YOUR VALUABLE BACKUPS ..The fault is with the partition table on your external hard drive.

Because of that, I would suggest you to try to connect the drive with a different cable and to a different port. ive tried searching their site to find WHERE I return the item to for replacement but cant find an answer??? Running %%860 on an out of support operating system is not an adequate solution to protect against threats.

please tell me the solution to take backup.

This may be due to a defect. Reply to Muhammad-Rizwan ChuckyJJSep 24, 2014, 8:49 AM Pitler said: My WD My Passport 500 gb decided to crash while I was traveling, having tons of travel photos, songs I've been What troubleshooting methods have you attempted?Try using the Data LifeGuard Diagnostic tool from our website and run both the QUICK and EXTENDED tests to check on the health and SMART status i tried above solution(quick and extended test).that will shows hard drive passed both tests.

Retest after checking the connections. I even made an image of the drive and got everything except the three stubborn sectors. i don't have another USB cable. have a peek at these guys It may also happen when the wrong version of diagnostic utility is used.

A hour later, a drive icon pops up in the Windows Explorer, but with no information about the drive. They can be compared to the 2/27/13 test earlier in the thread. Please ensure that you are using the proper version of diagnostic utility. I hope everything works out for you & best of luck with everything!SuperSoph_WD What else would I infer when I am getting the similar problem time & again?

Replace the drive if the error repeats. I hope someone else has any other ideas before I try reformatting it. Louis Forum Rules Report Topics For Staff Action BC Forums, List Preparation Guide Before Posting Malware Issues in MRL Forum Am I Infected Forum Back to top #14 anonanon anonanon Topic When I check off the 2 boxes under Check Now and click start ...

Create and use a new DLG Tools diskette. Retest. Roger ---------------------------- smartctl 5.43 2012-06-30 r3573 [i686-w64-mingw32-xp-sp3] (sf-5.43-1) Copyright © 2002-12 by Bruce Allen, http://smartmontools.sourceforge.net === START OF INFORMATION SECTION === Model Family: Western Digital Caviar Black Device SuperSoph_WD Reply to SuperSoph_WD praks001Oct 14, 2015, 4:49 PM This is a very common error in Western Digital hard drives.

Many WD models are afflicted with a "slow responding" issue which can be fixed with a single-click, if you have access to the right software, but you would need to prepare It does not show the 2nd drive at all. As I type with joyful strikes to the keyboard my information is being recovered after two years of thinking I lost it all. Please help got 1 year of pictures from travelling around the world Read and follow my solution.

Replace Drive 211 2-9 Uncorr ECC Errors Error Correction Code (ECC) 2 through 9.