Home > Western Digital > Western Digital Hard Drive Error Code 0226

Western Digital Hard Drive Error Code 0226

Please contact the system vendor for the above-mentioned information. If ECC occurs, use Data Lifeguard for additional error correction. Is there anything that suggests a serious problem with this hard drive? http://www.bleepingcomputer.com/forums/t/2520/how-did-i-get-infected/Forum Rules, The BC Welcome Guide 167 @ June 2015 Back to top Page 1 of 3 1 2 3 Next Back to Internal Hardware 2 user(s) are reading this topic check over here

This error may also appear if the floppy has been infected by a hidden virus. All disks have a small pool of back-up sectors, which are used to replace bad sectors in two distinct phases of an HDD life, first during manufacture and then during normal ECC is a hardware correction technique that corrects errors. If the error repeats, replace the drive. http://superuser.com/questions/679260/western-digital-sector-relocation-error-code-226

This may be a drive issue, however it may be related to a defective connection. Please ensure that you are using the appropriate version of diagnostic utility. Today when I booted up Win XP, I got an error message I'd never seen before. Check cable & retest.

Replace the drive if the error repeats. Error: (10/04/2014 09:43:25 AM) (Source: Microsoft Antimalware) (User: ) Description: The support for your operating system has expired. Re-Test Drive 203 DRM Attribute too low beforemedia scan. There may be repairable media errors on a platter.

Track 0 on the drive must be accessed to perform parts of various internal tests. If Selective self-test is pending on power-up, resume after 0 minute delay. webraider 2010-07-26 06:53:15 UTC #3 http://support.wdc.com/techinfo/general/errorcodes.asp "Failure to relocate a sector during drive repair. Clicking Here Please ensure that you are using the appropriate version of diagnostic utility.

Please re-test the drive with Data Lifeguard. Check cable and retest. This may be an anomaly. Would it be inappropriate to use my workplace's postage machine to mail my tax returns?

Several instances of information on data positioning and location could not be found. http://www.tacktech.com/display.cfm?ttid=282 Replace the drive. Replace drive if unable to correct error 118 DAM Error Data Address Mark (DAM) Error. If the automatic repair feature is unable to repair these errors, replace the drive.

Drive Reliability Monitor. check my blog There may be repairable media errors on a platter. This may be an anomaly. How Does a computer get Infected?

Replace Drive 557 SERVO 2-9 SERVO is data on track location. There could be media errors present on this drive. This may be due to a media error. http://txtbl.com/western-digital/western-digital-hard-drive-error-code-0223.html Latest Questions Latest Documents Terms & Conditions Privacy Policy Askiver © Copyright 2011-2016 & All Rights Reserved.

It also may be due to a defective connection. The same utility and the original code used to lock the drive are necessary to unlock this drive. A number of ECC errors (between 2 through 9) have been detected.

SCT Data Table supported.

Re-Test Drive 10 Set File Pointer Error A SetFilePointer command during the test has failed. Please ensure that you are not loading any other DOS level files from the floppy prior to running diagnostic utility. EasyOne™ Technical Manual - E-NESS EasyOne™ Technical Manual Page 2 1 Introduction The EasyOne™ spirometer uses digital ultrasonic flow measurement technology for fast, accurate, reliable operation. This may be due to a media or read/write error.

Drive should be replaced. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Drive should be replaced. have a peek at these guys Retest the drive.

Re-Test Drive 105 BUSY GLITCH The drive did not properly respond to test commands.