Home > Western Digital > Western Digital Error Code 0159

Western Digital Error Code 0159

Check Floppy and use appropriate diagnostic utility 207 Critical Resource Error Unable to locate and/or use a system resource (e.g. - printer). This may be due to a defect with the drive or a bad connection. An onboard defect counter has determined the drive has too many errors and should be replaced. There were media errors that were within the repair capabilities of diagnostic utility. http://txtbl.com/western-digital/western-digital-error-0159.html

Replace the drive if the error repeats. I know some WD hard drives have this and won't boot properly if they're setup as master with slave and don't have one. 09-19-2004, 07:15 AM #12 meat head Replace the drive if the error repeats. All times are GMT -7.

Further errors indicate a defective drive. Replace the drive if the error repeats. Replace Drive If an error code is encountered that is not in the list above, please Contact Us for additional troubleshooting. If ECC occurs, use Data Lifeguard repair option for additional error correction.

A clicking noise can indicate that this error has occurred. ECC is a hardware correction technique that corrects errors. A very accurate repairing and cleaning procedures must be made before the actual recovery starts for these types of problems. Several instances of information on data positioning and location could not be found.

Re-Test Drive 106 Track 0 Error Track 0 was not properly detected. There could be media errors present on this drive. Know the service cost in advance and save time, funds, and nerves. http://www.dslreports.com/forum/r17390860-hard-drive-Raptor-SMART-Failure-0159 Drive should be replaced.

Join and Comment By clicking you are agreeing to Experts Exchange's Terms of Use. Drive should be replaced. Flat rate to restore lost data from failed WD800AB 80Gb Western Digital hard drive. i ran Western Digital HD data lifeguard diagnostics..

Re-Test Drive with latest diagnostic utility 117 Uncorrectable ECC Error Uncorrectable Error Correction Code (ECC) Error. If the error repeats, replace the drive. Helpful (0) Reply options Link to this post by John Zwiebel, John Zwiebel May 17, 2015 11:16 AM in response to easierisbetter Level 1 (49 points) Apple TV May 17, 2015 i enabled SMART and still the same thing any ideas?

You may also want to reroute your IDE cable away from sources of electronic bus noise such as your CPU, Power Supply, etc. check my blog If you have any questions, then please Write a Comment below! This may be an anomaly or a defect with the drive. to report if a drive has failed, it must be enabled as a system option.

It's crazy frustrating. Re-Test Drive 257 ECC 2-9 Error Correction Code. It also may be due to a defective connection. this content Re-Test Drive 7 SMART Offline Immediate Command Failure Self-Monitoring, Analysis, and Reporting Technology (SMART) Offline Immediate command failed.

The drive should now be defect free. Test complete Defect Free 224 Errors not Repaired Errors found and have not been repaired. Drive should be replaced.

Replace Drive 584 Diag Command Error During a Quick Test, the sefl-test failed.

This error may also be related to memory issues. Re-test 132 Command Error Command Aborted. Replace the drive if the error repeats. Drive should be replaced.

Replace. Put the drive on the Secondary SATA Controller, and see... -Tursiops_G. · actions · 2006-Dec-3 6:59 pm · drrickEarth's mightiest hero.Premium Memberjoin:2002-07-09Chicago, IL

drrick Premium Member 2006-Dec-3 7:04 pm Yeah, I've Apple disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. have a peek at these guys The Identify Drive Command has not received an acceptable response from the drive.

Version 4.12 for older drives and version 5.00 for current drives. it wont give away the Primary Master None drive failure and it wont BOOT i managed to install 2k in it... Retest after checking the connections. Replace the drive if the error repeats.

Drive should be replaced. One day on boot up got "Primary Slave Hard Drive Failure" Bios recognizes the drive but it is not accessible with DOS or Windows programs. Most often these are indications of serious problems with mechanically moving parts like disk spindle or block of heads - when heads are literally grinding the disk platters. Replace the drive if the error repeats.

Re-test Drive with appropriate diagnostic utility 205 Aborted By User Test was aborted by the user (Alt-X pressed during a test). Retest after checking the connections. Retest. his computer only uses this hd but it wont boot...

Replace Drive 0009 - 0014 SMART Error Self-Monitoring, Analysis, and Reporting Technology (SMART) Error returned during SMART Status/Self Test Command. It is also possible to see this error on defective Western Digital drives. Several instances of track information could not be found. Replace Drive 212 Error while relocating TARE sectors.

Google just disclosed a major Windows bug - and Microsoft isn't happy [Security] by andyross232. This error can occur on non-Western Digital drives. Re-test Drive 135 DRQ Timeout Timeout from checking Data ReQuest Timeout (DRQ) bit. The headrack may need to be replaced in Dallas if it fails completely.The recovery will take 10 hours at $139 per hour plus parts ($150-$350) if needed and return media (1st

Re-test Drive 220 Drive is Locked Security feature of the drive reports locked status. Return to Top Data Lifeguard Tools 11 and 10 Error Codes Note: If the same error code is encountered more than once after re-testing, please Contact Us for additional assistance. Replace your cable and retest. Re-Test Drive 108 Seek Not Complete A Seek command did not complete in the time allotted.