Home > Western Digital > Western Digital Diagnostic Error 0132

Western Digital Diagnostic Error 0132

Replace. Re-test Drive with appropriate diagnostic utility 202 Drive Not Supported Older Western Digital drives are not supported by the diagnostic utility version being used. If ECC occurs, use Data Lifeguard repair option for additional error correction. Replace drive if unable to correct error 120 NO DRIVE FOUND Cannot communicate with drive. check over here

Check cabling and retest. There are too many errors detected on this drive to be repaired. Check your floppy and retest. Drive should be replaced. https://support.wdc.com/knowledgebase/answer.aspx?ID=11711

So, I rebooted, hoping to get into Windows XP and get my computer up and running again, NOT, it didn't work. Check your connections and replace the cable. Re-test Drive with appropriate diagnostic utility 133 Illegal ID FW overlay not found. It also may be due to a defective connection.

Replace Drive 219 Drive Cable Error Failure during cable test. General Purpose Logging supported. Extended self-test routine recommended polling time: ( 100) minutes. Between two to nine errors have been detected.

No Errors 0001-0015 SMART Error Self-Monitoring, Analysis, and Reporting Technology (SMART) Error returned during SMART Status/Self Test Command. This may be an anomaly or a defect with the drive. Other benefits of registering an account are subscribing to topics and forums, creating a blog, and having no ads shown anywhere on the site. This may be due to a media error.

http://www.bleepingcomputer.com/forums/t/2520/how-did-i-get-infected/Forum Rules, The BC Welcome Guide 167 @ June 2015 Back to top #4 anonanon anonanon Topic Starter Members 141 posts OFFLINE Gender:Male Local time:04:23 AM Posted 16 February 2013 I pulled up a command prompt and I accessed the "C" drive, but it was a false positive. Drive should be replaced. Track 0 also holds information about the drive.

Computers with S.M.A.R.T. http://www.motherboards.org/forums/viewtopic.php?t=104651 Check cable and retest. Continue to test or exit the test. First of all, the hard drive has worked fine for the last 1.5 years.

Replace the drive if the error repeats. check my blog to solve mankind's maladies.. Thanks in advance for any help. James Back to top #8 anonanon anonanon Topic Starter Members 141 posts OFFLINE Gender:Male Local time:04:23 AM Posted 03 March 2013 - 08:45 PM Thanks, I'll run chkdisk on it

To run in ATA 66 and ATA100 rates, an Ultra ATA 80 -conductor cable must be used. The drive has not responded in the time allotted. That is because most Windows systems use 4k as the smallest unit of disk measure (a cluster) and the bad sector (which is only .5k) is in that 4k cluster. this content Replace the drive if the error repeats.

Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Maybe yes, maybe no. The printer may not be attached or turned on.

The first 5% of a drive has the MBR and FAT tables.

The open file operation will fail with error -1032 (0xfffffbf8). This may be due to a defect with the drive or a bad connection. This error is most likely an internal malfunction of the drive and not related to the condition of the cables etc. Retest after checking the connections.

Replace Drive 200 Drive Not Tested Supported WD drives are initialized with this status. Further errors indicate a defective drive. Drive should be replaced. have a peek at these guys Check cabling and retest.

Replace the drive if the error repeats. Re-Test Drive 108 Seek Not Complete A Seek command did not complete in the time allotted. Check cabling & retest. Re-Test Drive 203 DRM Attribute too low beforemedia scan.