Home > Welch Allyn > Welch Allyn Thermometer Error Codes E5.0

Welch Allyn Thermometer Error Codes E5.0

Message: The sensor is defective. Causes: The Braun dock is disconnected from the device. Error Codes: Troubleshootingpage 24................................................................................................................................................................ Contact Technical Service. http://txtbl.com/welch-allyn/welch-allyn-thermometer-690-error-codes.html

Check that the gas source is not running out. try running it under hot water and see if it says error or high. Your new... Oldest record overwritten. http://www.welchallyn.com/en/service-support/answer-center/troubleshooting/cshm140-suretemp-plus-e-5-0.html

Message: Printer not functional. Message: Unable to determine NIBP, check connections and tubing for kinks. Causes: Tubing inside the NIBP module is kinked. Error Code: E11 - Cuff pressure duration exceeded.

Error Code: E10 - Cuff pressure limits exceeded. Reinstall probe well. Action: Remove the sensor from the patient and reapply. Retake reading.

Error Code: E33 - Internal malfunction. Clear the alarm and retry NIBP. If problem persists contact Technical Service. http://www.medwrench.com/?community.posts/threadNo/10880/subject/errir-E-50/ Message: Thermometer might be docked improperly.

Causes: The due date for calibration has passed. Clear and retry the NIBP. Causes: The printer does not identify itself correctly Causes: The printer does not enumerate Action: Call for service. Check patient condition and sensor position/contact.

Causes: The sensor is operation as an SpO2-only sensor because it failed to calibrate properly. http://electronicshelponline.blogspot.com/2013/08/how-to-troubleshoot-welchallyn-690.html Call for service. Check blood pressure off and tubing connections. Causes: The sensor was not detected.

Message: Excessive patient movement. http://txtbl.com/welch-allyn/welch-allyn-suretemp-plus-690-electronic-thermometer-error-codes.html Action: Re-enter the patient ID. Message: Check calibration gas concentration. Use an alternative sensor to monitor respiration.

Causes: An unqualified mattress type is in use Action: Switch to a qualified mattress type Message: Cannot measure respiration. Causes: An uninterrupted, error-free calibration took place. If problem persists, call for service. this content Action: Use the monitor in the specified temperature range.

Replace the filter line if necessary. Remove sensor from patient. System Messages: Message: Set date and time.

Ensure proper probe positioning.

Error Code: C01 - Blood pressure reading cancelled by user. How do i adjust volume of phone when talking? 4 months, from 10/31/2016 10/31/2016 Nathan We have a Reebok 9800 ES treadmill the display comes on and 10/31/2016 10/31/2016 Michael How Cause: The monitor's battery voltage is too low to support printing. Learn More Care Settings Government Primary Care and Clinics Hospital Long Term Care Other Care Settings PromotionsDownload Product Catalogs Exam Room Planner Parts & Accessories ‹ Back Batteries BP Cuffs Cables

Message: External device not recognized. Error Code: E0.8 - Cannot read the probe's configuration information. Replace probe. have a peek at these guys Error Code: C04 - Inflation too slow.

Change ambient temperature. Error Code: E42 - Internal malfunction. Check connections; restrict patient movement.