This may be due to a media or read/write error. The other drive did'nt get that far. enabled help you monitor a drive's internal status through diagnostic commands. You currently have 0 posts. "Friends, Family, Religion... navigate here
Please re-test the drive with Data Lifeguard. The Identify Drive Command has not received an acceptable response from the drive. It is also possible to see this error on defective Western Digital drives. There may be repairable media errors on a platter. https://support.wdc.com/knowledgebase/answer.aspx?ID=11711
Replace the drive if the repair fails. The printer may not be attached or turned on. Several instances of information on data positioning and location could not be found. Find More Posts by alien resident
Retest after checking the connections. Replace Drive 358 DAM 10+ Data Address Mark. Re-test Drive 206 Memory Allocation Error Unable to allocate memory for program structures. This may be due to a media or read/write error.
An error was reported by the drive during the Write command (to cause the auto-relocation) or the Read Verify command (to verify the relocation happened). Replace the drive if the error repeats. Please ensure that you are using the version of diagnostic utility corresponding to either newer or older Western Digital drives. over here Replace the drive if the error repeats.
Re-test Drive 206 Memory Allocation Error Unable to allocate memory for program structures. Replace the drive if the error repeats. The drive is a Western Digital 150.0GB SATA 10000RPM 3.5 16MB Raptor ( WD1500ADFD ) The problem is that the computer drops the drive when I try to partition/format it. Re-test Drive 220 Drive is Locked Security feature of the drive reports locked status.
Replace drive if unable to correct error 120 Unknown Error An unknown error has occurred during testing. http://www.abxzone.com/forums/showthread.php?t=103162 Re-test with appropriate diagnostic utility 228 DRIVE IS LOCKED-DST FAIL Security feature of the drive reports locked status. ive never had any problems with hard drives yet.i had one motherboard get fried because it was on a cheap surge protector.u may have to have someone look at the computer Retest.
Re-Test Drive 116 IDNF Error Address Not Found Error. check over here Use the appropriate version. SERVO is data on track location. It could be but I'm still going to bet my donkey on the problem being with the hard drive.
Card reader Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub Bus 002 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub Bus 003 Device 001: ID 1d6b:0001 Linux Replace Drive 210 Self Test Incomplete SMART Self Test failed to complete (e.g. -- timed out). Check Floppy and use appropriate diagnostic utility 207 Critical Resource Error Unable to locate and/or use a system resource (e.g. - printer). http://txtbl.com/wd-error/wd-error-code-223.html Replace drive if unable to correct error 120 NO DRIVE FOUND Cannot communicate with drive.
Unplugging the recently connected hardware device will help. Replace Drive If an error code is encountered that is not in the list above, please Contact Us for additional troubleshooting. Retest.
Re-Test Drive 121 Servo Error Servo error. Re-Test Drive 17 Erase SSD Failure A write command during the test has failed. Re-Test Drive 112 IRQ Timeout Interrupt ReQuest Interrupt signal not received. This may be due to a defect with the drive or the drive may not have responded properly due to a bad connection.
Show Ignored Content As Seen On Welcome to Tech Support Guy! Re-Test Drive with latest diagnostic utility 117 Uncorrectable ECC Error Uncorrectable Error Correction Code (ECC) Error. Drive should be replaced. http://txtbl.com/wd-error/wd-error-code-0258.html This is the pretest initialization code which indicates a drive is ready to be tested, but has not yet been tested.
If you're new to Tech Support Guy, we highly recommend that you visit our Guide for New Members. Re-test Drive 135 DRQ Timeout Timeout from checking Data ReQuest Timeout (DRQ) bit. Advertisement tomcon Thread Starter Joined: Nov 19, 2010 Messages: 9 hello.