Home > Wd Error > Wd Error Code 0008

Wd Error Code 0008

Re-test Drive 136 Bad Sector Sector Marked Bad Error. It is also possible to see this error on defective Western Digital drives. Error 14 occurred at disk power-on lifetime: 22 hours (0 days + 22 hours) When the command that caused the error occurred, the device was active or idle. One instance of track information could not be found. http://txtbl.com/wd-error/wd-error-code-223.html

Ten or more instances of information on data positioning and location could not be found. Test complete Defect Free 224 Errors not Repaired Errors found and have not been repaired. It also may be due to a defective connection. Is there any way to bring an egg to its natural state (not boiled) after you cook it? https://support.wdc.com/knowledgebase/answer.aspx?ID=11711

Extended self-test routine recommended polling time: ( 100) minutes. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x002f 200 200 051 Pre-fail Computers with S.M.A.R.T. enabled help you monitor a drive's internal status through diagnostic commands.

Who is DEGRADED? Please re-test the drive with Data Lifeguard. Hello and welcome to PC Review. Extended self-test routine recommended polling time: ( 100) minutes.

Louis Forum Rules Report Topics For Staff Action BC Forums, List Preparation Guide Before Posting Malware Issues in MRL Forum Am I Infected Forum Back to top #14 anonanon anonanon Topic Retest after checking connections. Retest after checking the connections. https://community.wd.com/t/two-brand-new-wd20ears-with-error-code-08/14004 Self-test supported.

This test gives me an error 0226 Sector Relocation Error The official recommendation is to replace the drive. Replace the drive. I'll put the Speccy output in a separate post. Brian, Jan 13, 2004, in forum: Computer Hardware Replies: 0 Views: 248 Brian Jan 13, 2004 Western Digital Raptor 36GB Serial ATA 10K DevilsPGD, Jan 22, 2004, in forum: Computer Hardware

Track 0 on the drive must be accessed to perform parts of various internal tests. more info here This may be an anomaly. This may be due to a media error. Replace the drive if the error repeats.

Re-test Drive 137 Relocated Sector Sector Relocated. check over here If the error repeats, replace the drive. Replace Drive 208 SMART status failed after the media scan. If Selective self-test is pending on power-up, resume after 0 minute delay.

Drive should be replaced. Drive should be replaced. Check your floppy and retest. his comment is here Re-Test Drive 102 Seek Timeout A Seek command did not complete in the time allotted for its completion.

Machine Messiah, May 18, 2004, in forum: Computer Hardware Replies: 8 Views: 405 Machine Messiah May 19, 2004 Western Digital Hard Drive Problem Sanbar, Jul 16, 2004, in forum: Computer Hardware Replace the drive if the error repeats. Re-Test Drive 18 Read Verify Sector Ext Error A Read Verify Sector Ext command during the test has failed.

The printer may not be attached or turned on.

You may need to rescan to ensure that the repairs were effective. At this moment, the spare pool sector is re-mapped to appear as occurring in the logical sequence at precisely the same spot as the de-commissioned sector. Replace the drive if the error repeats. Not the answer you're looking for?

Conveyance self-test routine recommended polling time: ( 5) minutes. Replace. Trademarks used herein are trademarks or registered trademarks of ESET spol. http://txtbl.com/wd-error/wd-error-code-0258.html Replace the drive if the error repeats.

Replace Drive If an error code is encountered that is not in the list above, please Contact Us for additional troubleshooting. Suspend Offline collection upon new command. Check cabling and retest. Total time to complete Offline data collection: ( 8400) seconds.

If ECC occurs, use Data Lifeguard repair option for additional error correction. Replace Drive 219 Drive Cable Error Failure during cable test. Hot Network Questions Why was Susan treated so unkindly? Offline data collection capabilities: (0x7b) SMART execute Offline immediate.

Self-test supported. Replace Drive 214 10+ DAM Errors Data Address Mark (DAM) 10+. Error: (10/03/2014 10:13:26 AM) (Source: Microsoft Antimalware) (User: ) Description: The support for your operating system has expired. Re-Test Drive 116 IDNF Error Address Not Found Error.

There were too many errors found on this drive to be repaired. Re-test Drive with appropriate diagnostic utility 204 Missing Log File The log file that existed at startup of diagnostic utility has been moved or no longer exists. Possibly the long test just checked the disk's surface. This may be due to a media or read/write error.

Sign In Upload Page of 19 Go Download Table of ContentsContents Print This PagePrint ShareShare Url of this page: HTML Link: Bookmark Comment Manuals Brands Western Digital Manuals Storage WD Quick Replace Drive 204 DRM Attribute too low after media scan. Replace Drive 256 ECC 1 Error Correction Code. Re-Test Drive 7 SMART Offline Immediate Command Failure Self-Monitoring, Analysis, and Reporting Technology (SMART) Offline Immediate command failed.